Pedals and amps
Find why your amp hums, safely.
60 Hz and friendsFind out why your amp hums. Answer a few questions for a ranked list of causes, or measure the hum with your mic. Every fix here is safe to try without opening anything.
It runs in your browser. In mic mode the audio is analysed on your device and is never recorded or sent anywhere.
Start with the guided check, then use the mic mode to confirm what you found.
Guitar amp hum finder
Safety firstNever open an amp. Its capacitors can hold lethal voltage even when unplugged and switched off. Never use a cheater plug, remove a ground pin or lift the mains ground. If a fix needs the amp opened or the wiring changed, take it to a qualified amp tech.
Step 1 of 8
Your answers
This listens through your device microphone, in your browser only. Nothing is recorded, stored or uploaded. The tool asks your browser to turn off echo cancellation and noise suppression so the hum is not filtered out. Phone and laptop mics lose low bass, so the tool reads the 2nd to 4th mains harmonics (120, 180 and 240 Hz on 60 Hz mains) as well as the base tone.
Mic level
Strongest tone–
Looks most like–
Confidence–
Spectrum from 20 to 1,200 Hz. Dashed lines mark the mains hum and its harmonics. Taller peaks on those lines mean mains hum.
Find the cause step by step
Each step records 5 seconds. Keep the mic about 30 cm (1 ft) from the amp speaker and keep the room quiet. Skip any step you cannot do.
What your steps show
| Step | Mains hum | Overall level | Change |
|---|
Levels are relative to your mic and are only good for comparing steps in this session. A change of 6 dB or more is treated as a real difference. This is a rule of thumb, not a lab measurement.
The microphone only runs while it is on. Press Stop microphone when you are done. Browsers ask for permission first, and listening needs a secure (https) page.
Embed this tool
Free for teachers, forums and gear blogs. Paste one snippet. No signup, no ads. Microphone mode needs the iframe to allow it.
Free tool by Sandy Music Lab
Quick answer: hum that appears with nothing plugged in points to the amp. Hum that rises with the guitar volume and changes as you turn around points to single-coil pickups and nearby electronics. Hum that drops on a different outlet points to a ground loop. Never open an amp, remove a ground pin or use a cheater plug. Use the guided check above to rank the likely causes in about a minute.